Thread: U.S.S. Kelvin
View Single Post
Old 6th Feb 2019, 06:50 PM   #20
Registered Member
3DS Max Photoshop After Effects Premiere
Join Date: Dec 2007
Posts: 91

3d modelers, I got a question if you can help me figure it out. I have an area that needs holding edges to keep a sharp panel line (marked in red). On the other side, I have a large cylinder that needs to smooth properly, so it can only have one edge running out (green). My solution for edge loop termination (blue) produces pinching and folding of the geometry after subdivision, as you can see. Any suggestions?

PixelMagic is offline   Reply With Quote